I replaced only the right low beam because that's the only one that burned
out.

But if I have to replace the left bulbs later, the black plastic shroud will
be a problem. I still don't know how to remove it without risk of damage,
and it must be removed to reach the clips and bulbs on that side.

Doe anyone here know what I'm talking about?

- Don

"Nick" <npolite@NOSPAMMONKEYS.yahoo.com> wrote in message
news:u3mrq0hbpmdonq8fu9o1utf8vbc3u1efmp@4ax.com...
> Usually all you have to do is press on the clip where the wires enter
> the bulb to release the connection and turn I believe counter
> clockwise to get the bulb out. I don't think that there is a
> difference in the headlight between the 4 cyl and 6 cyl model.
>
> Nick
>
> On Fri, 19 Nov 2004 02:32:30 GMT, "Don Enderton"
> <Enderton@nosuchaddress.duh> wrote:
>
>>Thank you, Randolph, for such a quick, clear and informed answer to my
>>first
>>question.
>>
>>Now, does anyone know the answer to my second question (see start of
>>thread), concerning how to remove that plastic shroud without damage?
>>It's
>>a part unique, I think, to the V6 Accord sedan of that series (1998-2002).
>>
>>- Don
>>
>>"Randolph" <trash@junkmail.com> wrote in message
>>news:419D3625.4FAA5541@junkmail.com...
>>>
>>> Don Enderton wrote:
>>>>
>>>> I'm replacing the right low beam bulb on my 98 Accord EX V6 sedan for
>>>> the
>>>> first time, which gives rise to two questions:
>>>>
>>>> 1) The owner manual says to use a 51 watt HB4 bulb, and that's also
>>>> stamped
>>>> right on the plastic near the bulb on the car itself. But most of the
>>>> HB4
>>>> bulbs I see listed by auto parts dealers are rated at 55 watts, not 51
>>>> watts. If I only replace one low beam bulb, will this cause a visible
>>>> mismatch in the amount of light from each side? Does it make any
>>>> difference
>>>> whether it's 51 watts or 55 watts? If so, does anyone know the brand
>>>> name
>>>> and dealers for a 51 watt bulb?
>>>
>>> There are several standards for rating automotive light bulbs. Some
>>> require the power to be measured at 12.8 Volts, others at 12.0 Volts
>>> (and I believe 13.2 Volts is used as well). HB4 / 9006 type bulbs are
>>> rated 55 Watts at 12.8 Volt, and 51 Watts at 12.0 Volts. Same bulb just
>>> measured at two different voltages.
>>>
>>> And in case someone finds that the numbers do not jive with Ohm's law,
>>> when you run the bulb at 12 Volts rather than 12.8 Volts, it will run a
>>> tad cooler, and the resistance of the filament will be a little less.
>>
>
>