Chopface wrote:
> Hello,
>
> I've been working on a '98 Civic HX with 108k miles on it. It was bought
> used, and had some sort of intial brake problem when test driven that
> was taken care of by the used car dealer it was bought from. I think the
> pedal was soft, so maybe it was just bleeding or master cylinder work.
>
> The driver's side front brake is sticking. This started after replacing
> the pads for the front brakes. I noticed when replacing the pads that
> the pads on the driver's side brakes were worn unevenly across the
> length of the pads. The upper pin of the caliper was not moving very
> freely and had to be cleaned up and lubed. Also, pushing the piston in
> with a c-clamp did not work until opening the bleeder. This was not
> required for the passenger side which was done first.
>
> The sticking did not occur immediately after replacing the brake pads.
> The car was driven at least 120 miles before the problem started. When
> the brakes started sticking the car was driven to the point of smoke
> being emitted from the brakes. After receiving advice from a mechanic I
> decided to replace the brake hose for the assembly. When doing the work
> I inspected the caliper and the piston and noticed the dust seal on the
> piston had melted. I got a used caliper from a junkyard and installed it
> and bled the system. The car was then driven for a solid 300 miles with
> no problems until the brake started sticking again. Its driving me nuts
> because I will drive the car and the brakes are fine and then as soon as
> I hand it over to my brother it starts sticking again.
>
> Anyone got any ideas about what could be the problem? Could it be the
> pipe from the master cylinder to the hose?
>
> Thanks for any ideas or advice,
>
> Mark

-------------------

Were _all_ of the brakes overheated, or just the one? Does it have ABS?
Has anybody had the master cylinder apart (and set the clearance so
tight so the brake boost is always ON)?

'Curly'